推荐施工方式：刷涂或喷涂。面漆建议用喷涂施工，漆膜效果更佳。
施工工艺：涂装工艺（以水曲柳板为例）
耗漆量（理论值）：面漆：8-10平方米/公斤(混合液，刷涂一遍的耗量)
底漆：5-7平方米/公斤(混合液，喷涂一遍的耗量)
(因基材、涂料颜色和效果不同，耗漆量会有所不同)
干燥时间(温度25℃、相对湿度75%)：表干时间小于60分钟 实干时间12小时
可使用时间(温度25℃、相对温度75%)：油漆混合后应在4小时以内用完。
重涂时间(温度25℃、相对湿度75%)：
如果采用湿喷湿涂饰方法，在漆膜表干以后马上重涂，中间无需打磨。但底
漆施工4小时，面漆施工8小时后如果还要进行下步涂装，则必须对涂层进行
打磨，以增加漆膜间的附着力。
施工注意事项：
①配漆时，将罐内油漆充分搅拌均匀，按规定比例调配，再次搅拌均匀，静
置10分钟后过滤使用。
②请将被涂物表面的灰尘、颗粒清理干净，再涂饰下一道漆。
③开罐后若油漆不能一次用完则必须即时密封。
④请配套使用本公司产品，以免引起不良反应。
⑤请根据温度的变化选择配套的稀释剂。
⑥基材的含水率应与当地的平衡含水率相当，表面要求干燥清洁。
⑦施工时应配戴防护用具，并保持良好通风。
⑧请根据施工难度和漆膜效果及时改变稀释的加入量。
储存方式：密闭存于阴凉干燥处，远离明火及热源。
符合国家标准：GB18581-2001

Recommended construction method: Brush or spray. Spray paint is recommended, the film better.
Construction Technology: coating process (as Ash board as an example)
Consumption of paint (theoretical): finish 8-10 square meters / kg (the mixture, brush over the consumption)
Primer :5-7 sq m / kg (the mixture, spraying over the consumption)
(Due to the substrate, coating with different colors and effects, the consumption of paint will vary)
Drying time (temperature 25 ℃, relative humidity 75%): dry time of less than 12 hours, 60 minutes drying time
Can use the time (temperature 25 ℃, relative humidity 75%): paint mixture should be used within 4 hours.
Recoat time (temperature 25 ℃, relative humidity 75%):
If the wet-jet wet coating method, immediately after the film is dry coating weight, in the middle without polishing. But at the end
Construction paint 4 hours, 8 hours after the finish the construction but also the next step if the coating, the coating must be
Polished, in order to increase the adhesion between the film.
Construction Notes:
① with paint, paint the tank, stir, according to the provisions of the proportion of allocation, stir again, the static
10 minutes after the filter is set to use.
② Please be coated surface of the dust particles to clean up, and then finishing the next coat of paint.
③ If the paint can that can not run out of time must be immediately sealed.
④ Please supporting the use of our products, so as to avoid adverse reactions.
⑤ Please select the package according to the temperature change of the diluent.
⑥ the moisture content of the substrate should be fairly local equilibrium moisture content, surface requires dry and clean.
⑦ construction should wear protective equipment, and maintain good ventilation.
⑧ film according to difficulty of construction and the addition of dilution effect of changes in the amount of time.
Storage: kept in a cool dry place sealed, away from open flame and heat.
Meet the national standard: GB18581-2001