Installation Instructions

Use the threaded holes in the end cap for mounting the linear actuator.
See if mid-section supports are needed using the maximum allowable
unsupported length graph on data sheet.
At least one end cap must be secured to prevent axial sliding when midsection
support is used.
When the linear actuator is moving an externally guided load, the clevis
mounting should be used.

The linear actuators can be fitted with the standard carrier mounting facing
in any direction. To prevent contamination such as fluid ingress, the actuator should be
fitted with its sealing band facing downwards.
The inversion mounting can be fitted to transfer the driving force to the
opposite side.